Audio Preset Memory; Audio Preset Recall - Kenwood DPX-U6120 Instruction Manual

Select "Audio Control"
"X'Over".
4
Select the speaker you want to set
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Front", "Rear", or "SubWoofer".
5
Select the item you want to set
Operation type
Selects the item.
Adjust each item.
Set the value
6
Repeat steps 4 to 5 to complete the X'Over
settings.
7
Exit Function setting mode
Press the [ ] button for at least 1 second.
Audio Preset Memory
Registering the value setup by Sound Control.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- <Car Type Selection> (page 37)
- <Speaker Setting> (page 37)
- <Car Type Fine Adjustments> (page 38)
- <X'Over Setting> (page 38)
- <Manual Equalizer Control> (page 33)
- <Listening Position Selection> (page 34)
- <Listening Position Fine Adjustments> (page 34)
2
Enter Audio preset memory mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Audio Control"
"Preset" > "Preset Memory".
3
Select the number to put in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select a preset number.
4
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "YES".
"Memory Completed" is displayed.
5
Exit Function setting mode
Press the [ ] button for at least 1 second.
⁄
•
Register 6 patterns of Audio Preset Memory.
•
Preset number "1":
> "Detailed Setup" >
Operation
Turn the [VOL] knob.
Press the [4] or [¢] button.
Press the [VOL] knob.
> >
"Detailed Setup"
When you press the Reset, all the sources will be the setting
value which is registered.
•
Preset number "1" and "2":
The memory cannot be erased by the Reset button.
•
This function cannot be registered when the iPod Equalizer
set in <Preset Equalizer curve Select> (page 33).
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 39).
1
Select the source
Press the [SRC] button.
Select a source other than "STDBY".
2
Enter Function setting mode
Press the [VOL] knob.
3
Enter Audio preset recall mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Audio Control"
"Preset" > "Preset Recall".
4
Select the number to recall in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select preset number.
5
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "YES".
"Recall Completed" is displayed.
6
Exit Function setting mode
Press the [ ] button for at least 1 second.
⁄
•
The "User" of <Preset Equalizer curve Select> (page 33) is
changed to the value which was recalled.
•
The Equalizer curve is changed to the value which was
recalled by the selected source.
> "Detailed Setup" >
English |
39