Stopping Printing Or Cutting Operations - Roland SOLJET SC-500 User Manual

Downloading Printing/Cutting Data

Stopping Printing or Cutting Operations

1
Press the [PAUSE] key.
The PAUSE LED lights up
If the "INK EMPTY" message appears while printing
If it becomes necessary to replace the ink cartridge while printing is in
progress, the buzzer sounds and the following message is displayed.
Please replace the ink cartridge.
If this message is ignored and printing is continued without replacing the
ink cartridge, image quality may be adversely affected and exhibit
faintness or other problems.
1
When [INK CONTROL]'s [EMPTY MODE] is
set to [LATER]
Press the [PAUSE] key to pause printing.
The PAUSE LED lights up
When [INK CONTROL]'s [EMPTY MODE] is
set to [PROMPT]
The unit pauses automatically.
About the [EMPTY MODE]
When replacement of the ink cartridge becomes necessary while printing is in progress, this setting determines whether printing
continues or pauses.
This setting is used when the ink cartridge cannot be changed immediately during printing, such as during unattended operation at
night. [LATER] causes printing to continue without pause even if ink refilling becomes necessary. Printing continues with the small
amount of ink remaining, so the printed image may become faint as the ink runs out. In general, it should possible to perform about 1
2 2
m (10 ft ) of printing once this message appears, although the actual varies widely according to the amount of ink needed for the
particular image. Printing is continued only for the data currently being printed. Operation stops after one image is output.
[PROMPT] causes operation to pause immediately when the ink cartridge needs to be changed. Printing is resumed by replacing the
cartridge and pressing the [PAUSE] key. Please note, however, that the colors of an image in progress may no longer be perfectly
matched if the unit is allowed to remain paused for two or three hours before resuming printing.
40
2
Halt transmission of print or cutting instructions from
the computer.
3
Hold down the [SETUP] key for one second or longer.
Any remaining data is cleared.
The SETUP LED goes out
INK EMPTY
[KCMcmY]
This indicates the ink color.
The color for which ink has run out flashes.
K = Black / C = Cyan / M = Magenta /
c = Light Cyan / m = Light Magenta /
Y = Yellow
2
Pull out the cartridge for the ink color that has run out,
and replace with a new cartridge (see "Replacing the
Ink Cartridges").
3
Press the [PAUSE] key to resume printing.
The PAUSE LED goes out
* Clearing the data
may take some
time.