Using The R-26 As An Audio Interface; Interface Mode; Audio Interface Block Diagram - Roland R-26 Owner's Manual

Connecting to Your Computer via USB

Using the R-26 as an Audio Interface

The audio input from the R-26 can be recorded via USB into software on your computer.
At the same time, recording and playback can be carried out on the R-26.
* You won't be able to play projects that have a different sampling frequency than the sampling
frequency that is set for the audio interface.
* Projects that are played back by the R-26 will be output from the PHONES jack. The output of
such project playback won't be available on your computer.
Main Screen for Audio Interface Mode
Audio interface mode
Input level to the PC
Input level from the PC
* On the R-26 itself, the source
to be recorded will be darkly
highlighted.
For instructions on how to set
the recording source, refer to
"Simultaneous Recording on
the R-26 Itself" (p. 90).

Audio Interface Block Diagram

PHANTOM
(XLR ONLY)
SENSE
LEVEL
INPUT 1/L
SENSE
INPUT 2/R
LEVEL
INT MIC
SENSE
XY
LEVEL
INT MIC
OMNI
PLUG IN
POWER
PLUG IN
MIC
86
AD LIMITER LOW
CUT
LOOP BACK LOOP BACK
LEVEL SW
USB
TO FROM
PC PC
DIRECT
MONITOR
REC
SD/SDHC Card
Tabs
PHONES
VOLUME
DA
PREVIEW
MONITOR
PLAY