Download Print this page
Roberts CR9923 Manual
Roberts CR9923 Manual

Roberts CR9923 Manual

2 band single alarm clock radio

Advertisement

Quick Links

CR9923
2 Band Single Alarm
Clock Radio
PM
FM
MW
TUNING
CR 9923
2 Band Clock Radio
Please read this manual before use

Advertisement

loading
Need help?

Need help?

Do you have a question about the CR9923 and is the answer not in the manual?

Questions and answers

Summary of Contents for Roberts CR9923

  • Page 1 CR9923 2 Band Single Alarm Clock Radio TUNING CR 9923 2 Band Clock Radio Please read this manual before use...
  • Page 2: Controls (Top)

    Controls (top) 1. Alarm set/off button. 2. Sleep button. 3. Minute button. 4. Hour button. 5. Time set button. 6. Snooze. Minute Hour SLEEP ALARM/OFF TIME SNOOZE...
  • Page 3: Controls (Front)

    Controls (front) 6. Alarm indicator. 7. PM indicator. 8. Tuning control. TUNING CR 9923 2 Band Clock Radio If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri)
  • Page 4 Controls (left and right side) 9. Function switch. Radio Buzz 10. Dimmer switch. 11. Waveband switch. 12. Volume control. DIMMER High 13. Battery compartment VOLUME...
  • Page 5: Setting The Time

    Switching on 1. Place your clock radio on a flat surface. Plug the power cord into the wall socket and switch on. The clock display will flash 12.00. TUNING CR 9923 2 Band Clock Radio TIME Setting the time 1. Press and hold down the TIME button. Minute Hour 2.
  • Page 6 Listening to the Radio 1. Switch on the radio by sliding the Function switch to the 'On' position. Radio Buzz 2. Select the required waveband using the Waveband selector switch. 3. Tune in to the desired station by rotating the Tuning control. The Wire aerial located on the rear of your clock radio is for FM reception.
  • Page 7 Setting alarm time ALARM/OFF Minute Hour 1. Press and hold down the ALARM/OFF button. 2. Whilst holding down the ALARM/OFF button press the Hour or Minute buttons to set the time. Release the buttons when the correct alarm time is reached. The clock uses a 12 hour display with a PM indicator.
  • Page 8 Setting the alarm to wake to buzzer 1. Set the alarm time as previously described. Set the Function switch to the 'Buzz' position. The Alarm indicator will light. The alarm will sound every day at the preset time for 1 hour 59 minutes.
  • Page 9 Snooze control 1. The radio or buzzer alarm can be silenced for 9 minutes by pressing SNOOZE the SNOOZE button. This sequence can be repeated whilst the alarm is sounding. Sleep timer SLEEP The radio can be set to turn off after a preset time has elapsed. 1.
  • Page 10 IEC size 6LR61 (6F22, PP3) Aerial System Wire Aerial Frequency Coverage 87.5 - 108MHz Built-in Ferrite aerial 525 - 1610kHz ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
  • Page 11 (Neutral) Blue marked L or coloured RED. Mains supply The CR9923 will operate from a supply of AC 230volts, 50Hz only. For your convenience this product is supplied with a plug which is fitted Cord with a fuse of the appropriate rating. If the plug supplied is not suitable...
  • Page 12 In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please contact Roberts Radio service department at the address shown below before taking further action.