IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Mains supply Back-up Battery The CR960 will operate from a supply of AC 230 volts, 50Hz only. Slide the battery cover catch (23) in the direction of the arrow. Remove the For your convenience this product is supplied with a plug which is fitted battery cover.
Page 5
Aerials The wire aerial located on the rear of the CR960 is for FM reception. The Alarm 1 = lower pitch HWS alarm signal wire should be fully extended and positioned for optimum reception Alarm 2 = higher pitch HWS alarm signal There is a built in ferrite aerial for MW stations.
Wake up to Radio Auto Dimmer Set the alarm time as previously described. Switch on the radio by pressing The Auto Dimmer (3) will automatically adjust the intensity of the clock the radio on button (14). Tune into the required station. Make sure that the display to suit room brightness.
2 x 0.5W RMS Frequency Coverage Aerial System Wire Aerial 87.5 -108MHz 520 - 1605kHz Built-in Ferrite aerial Imported by:- ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
Page 8
In the event that it is not possible to return the instrument to the Roberts dealer from whom it was purchased, please contact Roberts Radio Technical Services department at the address shown below before taking further action.
Need help?
Do you have a question about the CR960 and is the answer not in the manual?
Questions and answers