Service Mode; Service Mode Screen; Service-Mode Items And Descriptions - JUKI HZL-G Series Service Manual

6-19 Service mode

6-19-1 Service mode screen

[How to select the service mode]
. Turn the power switch OFF. In this state, turn the power switch ON with the two buttons (see the
description below) held pressed simultaneously.
・ HZL-G20: Reverse stitch button and thread trimming button
・ HZL-G0: Reverse stitch button and needle up/down button
2. The service mode screen appears on the display. Select the number corresponding to the service item to
operate.
* To select the corresponding number, advance or return the item one by one by means
of the pattern selection button

6-19-2 Service-mode items and descriptions

No. Item name
0 Version check mode
 FEED 0 MODE
2 FAGOTT
3 DARNING
4 ZIG ZAG
5 KIKKOU
6 OVERCASTING
7 BLIND STITCH
.
The version is displayed when the sewing machine enters the Service Mode.
Press the OK button to display the model; i.e., "20" or "0".
Select the straight stitch pattern and set the amount of feed at 0 (zero).
Press the "OK" button to initialize the pattern to set the amount of feed to
zero (0).
Select the fagoting pattern.
Set the zigzag width at 7.0 mm.
The fagoting pattern can be sewn.
Select the darning pattern and adjust the lengthwise feed.
Darning pattern can be sewn with the initial value.
Select the zigzag pattern.
Zigzag pattern can be sewn with the initial value.
Select the Kikkou pattern.
Kikkou pattern can be sewn with the initial value.
Adjust the needle entry point for overcasting.
Slide the needle entry points toward the needle throwing direction entirely by
the specified number of pulses.
The sliding amount can be adjusted with the "zigzag width adjusting" button.
The adjustable range of the sliding amount is [-4 to 4]. Adjustment is made in
increments of .
Adjust the needle entry points on the left side of the blind stitch.
Slide the needle entry points toward the needle throwing direction entirely by
the specified number of pulses.
The sliding amount can be adjusted with the "zigzag width adjusting" button.
The adjustable range of the sliding amount is [-4 to 4]. Adjustment is made in
increments of .
– 30 –
OK button
HZL-G210
Description
OK button
HZL-G110