JUKI HZL-G Series Service Manual page 11

9) Front panel
@0
Notch
C
B
Z
10) Rear panel
○ Remove setscrews
○ Put a thin screwdriver in the notch in the rising section under the arm and pry
off the front panel and hook
○ Opening the right side of the front panel in the direction of the arrow, tap
section with your hand to remove hook
○ Lastly, remove hook
○ Remove connectors for SUMI-card, start switch and LED lamp from the
microcomputer PCB when necessary.
@1
Open
A
○ Remove setscrews
Remove the rear panel with the presser foot lifting lever raised.
@2
and from the front panel.
@0 @1
of the rear panel.
A
B
located at the lower side of the machine jaw.
C
, and from the rear panel.
@2 @3 @4
@4
– 8 –
located at the bed surface.
@3
Z