Optional Parts - JUKI HZL-30Z Instruction Manual

Optional parts

Invisible zipper foot
Pattern to be used
HZL-30Z HZL-60
Since a seam does
not appear on the
right side of fabric,
opening can be fin-
ished with fabric
edges neatly butted.
CAUTION:
Make sure to turn
off the machine
before changing
the presser foot.
1.
Check the zipper opening size. Install
the standard presser foot (A).
Basting
Fabric
(wrong side)
Runstitch
Place two pieces of fabric face to face. Baste the
fabric from the edge of fabric to the opening end.
At the opening end, change the stitch length to
[2.0] and sew reverse stitches by 1 cm and sew
until the predetermined position is reached.
Neatly open the seam allowance.
3.
Undo the basting stitch seam to the bot-
tom of opening as shown in the sketch
given in step 1. Then, open the zipper.
5.
Sew the remaining zipper tape on the other side of seam
allowance in the same procedure. (The lower portion of
zipper tape located below the bottom of the opening will
remain loose without sewn on the seam allowance.)
2.
Fabric
(wrong side)
2.5 cm
Reverse stitch (1 cm)
Put the invisible zipper on the fabric so that its
center meets the seam line. Place a cardboard
between the seam allowance and front fabric.
Manually baste both sides of seam allowances
and zipper tapes.
Upon completion of basting, remove the card-
board.
4.
Aligning the teeth of either zipper tape with the groove
on the zipper foot, sew the zipper at the very edge of
the teeth from the end of opening while raising the teeth
with fingers.
Invisible
zipper foot
Tape
Teeth
Seam Fabric
Basting
(only zipper tape and
Basting
seam allowance)
Invisible zipper
(wrong side)
Cardboard
Tape
Seam
6.
Slider
Take out the slider and pull it out to ap-
pear on the right side of the fabric.
Invisible
zipper foot
Fabric
Teeth
22