JUKI HZL-30Z Instruction Manual page 11

Automatic Needle Threading
1.
Push the threading lever
down.
HZL-30Z
(A)
HZL-60
(A)
Lower the threading lever
and place the thread onto
(A).
Pulling Up The Bobbin Thread
1.
Hold the needle thread lightly with
the left hand and turn the handwheel
toward you until the needle enters the
needle plate.
HZL-30Z
HZL-60
Continue turning the handwheel while
holding the needle thread until the needle
rises.
2.
Push the threading lever
all the way down and a hook
will go through the eye of the
needle.
HZL-30Z
Hook
HZL-60
Hook
Pass the thread in front of the
needle and below the hook.
2.
Turn the handwheel
toward you.
HZL-30Z
HZL-60
Undo the loop with your finger.
* Check to be sure that the needle is in its highest position.
3.
Slowly release the needle
threader and it will return to
its original position.
HZL-30Z
HZL-60
3.
Pull both the needle and bobbin
threads out by 10 cm.
HZL-30Z
HZL-60
4.
Pull the loop of thread
that is at the back of the
needle out about 4".
HZL-30Z
HZL-60
10