How To Use The Operation Panel; Names And Functions Of Each Components - JUKI IP-110 Instruction Manual

3. HOW TO USE THE OPERATION PANEL

3-1. Names and functions of each components

!6
!8
!7
1 ­Re-sewing­switch
2 ­Needle­up/down­compensating­switch
3 ­Screen­changeover­switch
4 ­With/without­reverse­feed­stitch­at­sewing­start­switch
5 ­With/without­reverse­feed­stitch­at­sewing­end­switch
6 ­Reset­switch
7 ­Teaching­switch
1 ­Re-sewing­switch
2 ­Needle­up/down­
­­­­­compensating­switch
3 ­Screen­changeover
­­­­­switch
4 ­ With/without­reverse­feed­stitch­
at­sewing­start­switch
5 ­With/without­reverse­feed­stitch­
at­sewing­end­switch
6 ­Reset­switch
1 3 4
2
5
8 ­Information­switch
9 ­Material­edge­sensor­switch
!0 ­ One-shot­stitching­switch
!1 ­ With/without­automatic­thread­trimmer­switch
!2 ­ Thread­trimming­prohibiting­switch
!3 ­ Counter­value­setting­switch
!4 ­ Max.speed limitation variable resistor
This­switch­is­used­to­continue­sewing­from­the­step­on­the­way­
after­ replacing­ bobbin­ thread­ when­ bobbin­ thread­ has­ run­ out­
during­program­stitching­step.
This­is­the­switch­to­perform­needle­up/down­compensating­stitching.­
(Needle­up/down­compensating­stitching­and­one­stitch­compensating­
stitching­can­be­changed­over­with­function­setting­No.­22.)
This­is­the­switch­to­change­over­the­screen.
This­ is­ the­ switch­ to­ turn­ ON/OFF­ automatic­ reverse­ feed­ stitch­
at­sewing­start.
*­­ T his­switch­cannot­be­used­with­the­sewing­machine­which­ is­
not­provided­with­automatic­reverse­feed­stitching­device.
This­ is­ the­ switch­ to­ turn­ ON/OFF­ automatic­ reverse­ feed­ stitch­
at­sewing­end.
*­This­switch­cannot­be­used­with­the­sewing­machine­which­ is­
not­provided­with­automatic­reverse­feed­stitching­device.
This­is­the­switch­to­make­the­value­of­bobbin­thread­counter­or­
sewing­counter­the­set­value.
!0
!4 !1
­ – ­3­–
!5
9 6 !3
!2
8
!5 ­ Power­display­lamp
!6 ­ Media­cover
!7 ­ Media­slot
­­­­­(Media­inserting­opening)
!8 ­ CompactFlash(TM)
­­­­­(Optional­:­Part­No.4000000)
7