5-13. Setting for functions
(1) How to change over to the function setting mode
Do not perform switch operations other than those described in the following explanations.
Be sure to re-turn the power switch ON after one second or more has passed. If the power is
turned ON immediately after turning it OFF, the sewing machine may not work normally. In this
case, turn ON the power again.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
Therearetwokindsoffunctionsettings,LevelandLevel2.
Level:ChangeofsettingcanbeperformedwithoutturningOFFthepowerswitch.
Level2:ItisnecessarytoturnOFFthepowerswitchafterchangeofsetting.
ForthedetailsofsettingNo.,seeP.70.
[Setting procedure of Level 2]
) TurnONthepower.WhentheneedlebarisnotinitsUPposition,turnthehandwheeltobringtheneedle
bartoitsUPposition.
2
3
SettingNo.
3
4
– 67–
1
Setvalue
2) Pressswitch 1 for
approximately three
seconds.
3) Pressswitch 2 for
approximately three
seconds.
4) Thisscreenisthefunction
settingscreen.
ChangethesettingNo.
with"+/–"Keyofswitch 3 .
Forthedetailsofsetting
No.,seeP.70.
Example) Changing the
flicker reducing
function
(Setting No. 5)
ChangethesettingNo.to"5"
with"+"Keyofswitch 3 in
the figure above.
• Pressswitch 4 .