Communication Mode - JUKI IP-110 Instruction Manual

(3) Communication mode

Changing­procedure­to­the­communication­mode
Do not perform switch operations other than those described in the following explanations.
Be sure to re-turn the power switch ON after one second or more has passed. If the power is
turned ON immediately after turning it OFF, the sewing machine may not work normally. In this
case, turn ON the power again.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
)­ Turn­ON­the­power.­When­the­needle­bar­is­not­in­the­UP­position,­turn­the­handwheel­to­bring­the­needle­
bar­to­the­UP­position.
2)­­Press­switch­ 1 for approximately three seconds.
3)­ Press­ switch­ 2 for approximately three seconds. The screen changes to the communication mode
screen.
■ Communication mode screen
1
2
­ – ­77­–