How To Use The Operation Panel; Names And Functions Of Each Components - JUKI IP-110 Instruction Manual

2. HOW TO USE THE OPERATION PANEL

2-1. Names and functions of each components

!6
!8
!7
1 Re-sewng swtch
2 Needle up/down compensatng swtch
3 Screen changeover swtch
4 Wth/wthout reverse feed sttch at
sewng start swtch
5 Wth/wthout reverse feed sttch at
sewng end swtch
6 Reset swtch
7 Teachng swtch
1 Re-sewng swtch
2 Needle up/down
compensatng swtch
3 Screen changeover
swtch
4 Wth/wthout reverse feed
sttch at sewng start
swtch
5 Wth/wthout reverse
feed sttch at sewng end
swtch
6 Reset swtch
1 3 4
2
5
8 Informaton swtch
9 Materal edge sensor swtch
!0 One-shot sttchng swtch
!1 Wth/wthout automatc thread trmmer
swtch
!2 Thread trmmng prohbtng swtch
!3 Counter value settng swtch
!4 Max.speed lmtaton varable resstor
Unused
Ths s the swtch to perform needle up/down compensatng sttchng.
(Needle up/down compensatng sttchng and one sttch compensatng
sttchng can be changed over wth functon settng No. 22.)
Ths s the swtch to change over the screen.
Ths s the swtch to turn ON/OFF automatc reverse feed sttch at
sewng start.
* Ths swtch cannot be used wth the sewng machne whch s not
provded wth automatc reverse feed sttchng devce.
Ths s the swtch to turn ON/OFF automatc reverse feed sttch at
sewng end.
* Ths swtch cannot be used wth the sewng machne whch s not
provded wth automatc reverse feed sttchng devce.
Ths s the swtch to make the value of bobbn thread counter or
sewng counter the set value.
!0
!4
!1
– 2 –
!5
9 6
!2 8
!5 Power dsplay lamp
!6 Meda cover
!7 Meda slot (Meda nsertng openng)
!8 CompactFlash(TM)
(Optonal: Part No. 4000000)
!3
7