Darning Stitch - Janome Sewing Machine Instruction Book

q w
z x c v
q
r
t
e
y
e
w
e
u
i
o

Darning Stitch

q Stitch pattern:
w Thread tension dial:
e Presser foot:
• Starting to sew
z Pull the button holder q to the back.
x Place the garment under the foot. Press the needle
up/down button twice. Move the fabric to the
left to draw both threads under the foot.
c Lower the foot and start the machine.
The machine will lock stitch, sew 16 rows of darning,
lock stitch again and stop automatically.
v Turn the fabric and repeat sewing.
q Button holder
w Hole
e Starting point
r 3/4˝ (2 cm)
t 9/32˝ (0.7 cm)
• Sewing a shorter darning
To sew a darning shorter than 3/4˝ (2 cm), first stop the
machine after sewing the required length u, then press
the reverse stitch button y.
The required length u has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
y Reverse stitch button
u Required length
i Starting point
• Sewing a same-sized darning
Simply start the machine to sew another darning at the
same size.
• Adjusting the evenness of the darning
Correct the evenness of the darning as follows:
Press the cursor buttons
under the value "d5" o (default setting).
When the right side of the darn is lower than the left side,
press the button to set the value to "d6" – "d9", and
make the darn even.
When the left side of the darn is lower than the right side,
press the button to set the value to "d1" – "d4", and
make the darn even.
30
08
3 to 6
Automatic buttonhole foot R
to move the cursor