Table of Contents
Advertisement
PRJ-WALLKIT-13
Cable Management (Optional)
1.
Route cables/cords from projector through opening on
projector arm and route to wall. (See Figure 18)
2.
Guide cables/cords from wall end of projector arm upward
or downward through slots in wall plate. (See Figure 18)
2
2
Projector arm
opening
Figure 18
Add Plastic Covers
1.
Add right and left plastic covers (E and F) over brackets.
(See Figure 19)
2.
Fasten covers using four 10-24 x 5/8" Phillips cap head
screws (HB). (See Figure 19)
2
1
(E)
(A)
2
(HB) x 2
Figure 19
12
1
Projector
(projector not shown)
(HB) x 2
(F)
1
Visit the InFocus support site at www.infocus.com/support
3.
Add end cap (D) to end of short throw projector arm. (See
Figure 20)
3
(D) x 1
Figure 20
Installation Instructions
(projector not shown)
Advertisement
Table of Contents
