Table of Contents
Advertisement
3. Wiring Controller
Connect the 3-conductor cable to the captive screw connector on the back of the
Wall Remote. Be sure that the wires agree with the connections on the Cable
Assembly end (page 4). For example, the wire landing at the +6V position on the
terminal block should connect to +6V position on the Wall Remote.
Note: Verify the captive screw connectors are fully open (turned counterclockwise)
before inserting the wires. If the screws are turned the wrong way to secure the
wires, they can make a physical connection without making an electrical connec-
tion.
Note: The sequence of labeling is the same on the terminal block and the Wall
Remote; e.g. the Wall Remote uses cross-over wiring.
IV. Wall Remote Installation cont'd
Wire landing must match
landing on barrier strip at the
display device side
(see pg. 4).
7
Advertisement
Table of Contents
