Table of Contents
Advertisement
Cloning cont'd
Once the units are correctly
lined up, the donor Wall
Remote will automatically
enter cloning mode.
When the clone Wall
Remote makes contact with
the donor, its LED will also
turn solid red.
3. Hold the clone unit
steadily in front of the
donor for about 15 sec-
onds. Both units will chirp
rapidly to indicate their
progress. If the connection
is broken (the clone unit
ceases to chirp), reposition
the clone unit and the Wall
Remotes will pick up where
they left off. If communica-
tion is broken for a signifi-
cant period of time (about
approx. one inch apart
15 seconds), the clone unit
facing each other
will time out and you will
need to begin cloning again.
4. When the clone unit has completed copying codes from the donor, it will beep
loudly 3 times and reset. You will see all of the button LEDs flicker in quick succes-
sion. After the Wall Remote has reset it will be fully operational, and it will have
learned all of the codes programmed into the donor unit.
The donor unit will remain in cloning mode for approximately 15 seconds until it
times out. It will then return to normal operation.
VII. Complete Installation
To complete the installation, secure a standard wall
plate (not included) over the face of the Wall Remote.
The outer screw holes on the Wall Remote should be
used to secure the wall plate.
15
Advertisement
Table of Contents
