Table of Contents
Advertisement
III. Wiring at Display Device
The Wall Remote connects to
the Cable Assembly terminal
block with the included three-
conductor cable. The cable
brings power to the Wall
Remote from the Cable
Assembly, and carries IR sig-
nal to the display device from
the Wall Remote.
Run the included three-con-
ductor cable from the display
device and wall outlet to the
Wall Remote.
At the display device side,
connect the three-conductor
wire to the Cable Assembly
terminal block (included).
Attach the IR emitter bud to
the appropriate IR window of
the AV device.
Note: Some devices are
extremely sensitive to exact bud placement. Be sure that the IR emitter bud is
placed directly over the IR receiver.
Connect the three-conductor cable to the screw down posts in the terminal block.
The three used positions on the terminal block are clearly labeled +6V, Gnd, and
IR. You will match the wires to the corresponding positions on the Wall Remote
captive screw connectors with identical labels.
Note: The unlabeled position on the terminal block should be unwired.
Affix the terminal block to any con-
venient surface with the provided
double-sided tape.
Warning: Do not rewire the IR
emitter! The emitter is protected
by a 150 ohm current-limiting
resistor. Connecting it directly to
the 6VDC power supply will dam-
age the emitter.
6 VDC
Wire landing must
match Wall Remote
landing (see page 7).
Cable Assembly
IR Emitter
4
Advertisement
Table of Contents
