Table of Contents
Advertisement
4. Install Controller
IV. Wall Remote Installation cont'd
Optional: Mount the Wall Remote to a single-gang wall box (not included). The
inner screw holes on the Control Board should be used to affix the Wall Remote
to the wall box. The outer screw holes will be used to affix a wall plate over the
face of the Wall Remote (see Part VII. Complete Installation).
Plug in the 6V wall wart to power the Wall Remote.
Warning: The Wall Remote is a low-voltage device. Never install the Wall
Remote in an electrical back box containing high-voltage wiring. This would
cause a serious electrical danger and violate United States national electrical
codes.
5. Configure Wall Remote Audio Feedback (optional)
By default, the Wall Remote will respond to button presses with an electronically-
generated click sound. To toggle this sound on and off, press and hold any button
on the Wall Remote while inserting a paperclip into the Wall Remote programming
aperture. The Wall Remote will beep quickly three times to indicate that AUDIO has
been set to OFF.
Caution: Be gentle with the paper clip to ensure that you do not damage switch
mechanism.
8
Advertisement
Table of Contents
