Table of Contents
Advertisement
VIII. Operation
The Wall Remote must always be powered on. The LED backlit buttons will remain
continually illuminated.
Power
Power button inserts are used to control
power on the projector or monitor. Toggling
power buttons will toggle power on and off;
discrete power buttons have independent
control for power on and off.
Discrete
Toggling
Note: POWER buttons do not power the
Wall Remote on and off; the Wall Remote will always remain on.
Source
Source button inserts are used to control
input selection on the projector or monitor.
Each source button may be programmed
with as many as four separate input com-
mands. To select the desired input, press
the appropriate input selection button as
Toggling
Discrete
many times as necessary to cycle through
the available inputs.
Note: Some projectors or monitors will not allow switching to an input if a signal is
not present on that input.
Volume
Volume button inserts are used to control
volume on the projector or monitor.
Press the upward-facing volume button
(right side) to raise device volume. Press
Control
the downward-facing volume button (left
Blank
side) to lower device volume.
If the Wall Remote is not used to control volume, a blank button insert may be
used.
16
Advertisement
Table of Contents
