Table of Contents
Advertisement
2. Attach Bezel
Once you select the three insert modules appropriate for your device remote con-
trol, place the insert modules right-side-up against the circuit board. Secure them
into place with the bezel.
Bezel
Be sure the bezel is correctly placed right side up. The top side of the bezel has
two small circular cut-outs designed to fit over the IR receiver window and the
Status LED.
Note: It is possible to remove the bezel from the
front of the unit after installation. Insert the tip of a
flathead precision screwdriver into the four slots
adjoining the bezel mounting pegs and gently
lever them inwards to free the bezel.
Inserts
IV. Wall Remote Installation cont'd
Control
Board
6
Advertisement
Table of Contents
