Local Devices; Recovery - HP Data Protector A.06.11 Recovery Manual

or DNS server. In order to update the first diskette from the ASR set, repeat the whole
procedure, but you do not have to select the Copy DR installation check box. This
option copies the DR installation files (to a selected destination), which do not need
to be updated.
IMPORTANT:
It is recommended to restrict access to ASR diskettes due to security reasons.

Local devices

If you are using a locally attached device for ASR, test if it is supported. To do so,
perform the following steps:
1. Run devbra -dev from the command prompt (from
Data_Protector_home\bin).
2. Rename the scsitab file (located in Data_Protector_home) and run devbra
-dev from the command prompt again.
3. Compare the both outputs of the devbra -dev command. If they are identical,
ASR using this device is possible, otherwise copy the scsitab file to the first
ASR diskette. You have to copy the scsitab file only the first time you are
preparing the ASR set. You do not have to copy it when you are only updating
the ASR set. See the online Help index: "support of new devices".
4. Rename the scsitab file back to the original name.

Recovery

To successfully perform a disaster recovery of the affected system, you need the
following:
• A new hard disk to replace your affected disk.
• A successful full client backup of the client that you want to recover.
• Updated ASR set.
• Windows installation medium.
The following is a step-by-step procedure for performing ASR:
1. Boot from the Windows installation medium.
2. Press F2 during the start of the OS setup to enter the ASR mode.
3. Provide the first (updated) diskette from the ASR set.
Disaster recovery guide 93