The Drm.cfg File; Disaster Recovery Wizard - HP Data Protector A.06.11 Recovery Manual

1. When the Disaster Recovery Wizard appears, press any key to stop the wizard
during the countdown.
Figure 12 Disaster recovery wizard
2. Click Cmd to start the command prompt.
3. Run the following command:
echo variable > %SystemRoot%\system32\OB2DR\omnirc
where variable is the omnirc option exactly as it should be written in the
omnirc file.
For example:
echo OB2RECONNECT_RETRY=1000 >
%SystemRoot%\system32\OB2DR\omnirc
This command creates an omnirc file in the disaster recovery operating system
with the OB2RECONNECT_RETRY variable set to 1000 seconds.
4. Close the command prompt and click Next in the Disaster Recovery Wizard to
proceed with disaster recovery.

The drm.cfg file

The Data Protector disaster recovery configuration is set up to cover a broad range
of system configurations. However, in some cases, these settings may not be the most
appropriate, or you may want to modify some of the settings in order to troubleshoot
issues on your system.
Disaster recovery guide 137