Verifying The Default Block Size - HP Data Protector A.06.11 Recovery Manual

• During OBDR backup, the partition on which Data Protector is installed should
have at least 200 MB of temporary free space. This space is required to create
a temporary image.
• All drivers, required for boot must be installed under the %SystemRoot% folder.
• Network must be available when you boot the system in Safe Mode with
Networking or in Directory Services Restore Mode (Domain Controller only), but
you must do the backup of the system after it was booted with normal boot process.
• A media pool with a Non-appendable media usage policy and Loose media
allocation policy has to be created for the OBDR capable device. Only the media
from such pool can be used for disaster recovery.
• When backing up the client, the default 64 kB block size should be used to write
to the device if you plan to perform an offline restore. This is the only default block
size available on Windows when performing disaster recovery. To verify that the
default 64 kB block size is set, choose Advanced in the Properties box, as shown
in Figure 4 on page 73.
Figure 4 Verifying the default block size
Disaster recovery guide 73