Regency F37-LPG Owners & Installation Manual page 23

4) Remove the two outside frame pieces by
removing two screws per side. See diagram
below.
5) At this point you should disconnect the gas
at the valve. You can access it through the
front now that the control panel is off, or you
can access it through the rear pedestal cover
plate.
6) Carefully remove the logs and embers.
7) Remove burner. See diagram below.
Note: Use a magnetic type screwdriver if
possible.
8) Remove all 18 screws holding the burner
tray assembly in place.
®
F37 Regency Rear Flued Room Sealed Freestanding Gas Heater
9) Carefully lift the burner tray assembly out.
Be careful not to tear gaskets when lifting
out the valve tray; these gaskets seal the
valve from the exterior of the fi rebox.
10) To replace the burner tray assembly, simply
reverse these instructions.
MAINTENANCE
23