Xacti Link - Sanyo LCD-32K40 Owner's Manual

BASIC OPERATION
This is a system control function by which, through an HDMI cable, a control signal is output to electronic
devices and the operation of multiple devices is coordinated. The HDMI-CEC function will operate
correctly only when the Xacti whose model is VPC-HD1010, VPC-HD2000, VPC-FH1, VPC-TH1 or
VPC-WH1 is connected to a SANYO TV that incorporates the HDMI-CEC function.
1 Select HDMI SETTING in SETUP menu. Then press ◄►
buttons to enter HDMI SETTING menu.(Figure A.) Select
"XACTI LINK ON" by pressing ◄► buttons. (The details
for operation, please refer to "SETUP" on page 38.)
2
Select "HDMI-CEC ON" in Xacti menu as Figure B.
( For the details, please refer to "TV OUTPUT SETTING"
on the INSTRUCTIONS MANUAL(Xacti).)
3
Make sure that HDMI input is connected to Xacti if Xacti
button is pressed. (The connecting way, please refer to
"Connecting to the HDMI terminal" on the INSTRUCTIONS
MANUAL(Xacti).) After connecting the Xacti to the
television, switch the TV input to the terminal which the
Xacti is connected.
Press Xacti button to enter DISPLAY mode.(Figure C.)
4
Press ▲▼ buttons to select any picture. Press OK button
to display selected picture. And you can operate the
selected picture by following buttons on Remote Control.
(Note: For the details, please refer to INSTRUCTIONS
MANUAL(Xacti).)
●
RED(W) button: Works the same as pushing zoom switch
●
GREEN(T) button: Works the same as pushing zoom switch
●
YELLOW button: It operates as a preservation button to
●
BLUE(MENU) button: Open or close the Xacti menu.
5 Press Xacti button or RED button to return to the DISPLAY
mode.
6 To exit Xacti mode, select "XACTI LINK OFF" in HDMI
LINK menu. (The details for operation, please refer to
"SETUP" on page 38.)
Note:
●
When "XACTI POWER OFF" is set to "ON", the power supply
of Xacti will switch to off if you turn off the television.
●
When "XACTI POWER ON" is set to "ON", the power
supply of television will switch to on if you turn on the Xacti.
●
The menu of Xacti will not open when open the television
menu.
●
Message of "Please switch Xacti to the PLAY mode and
connect it." will display on the screen when in the Xacti
REC mode.
●
Only SANYO Xacti camera with HDMI-CEC that corresponding
to this LCD TV (please refer to SANYO Xacti camera model
with HDMI-CEC on page 48).
26
LCD-K40.indd 26

XACTI LINK

toward the [W] side.
toward the [T]side
the animation edit.
REMOTE CONTROL
OK button
POINT ▲/▼/◄/►
buttons
Xacti button
RED(W) button
GREEN(T) button
BLUE(MENU) button
YELLOW button
Figure A.
SETUP
HDMI LINK
XACTI LINK ON
XACTI POWER ON OFF
XACTI POWER OFF ON
: SELECT : ADJUST : BACK
Figure B.
OFF
Figure C.
: EXIT
1/21/2010 10:47:22 AM