Light Assembly; Connecting Power - Genie screwdriver Assembly & Installation

Screw drive models
Table of Contents

Advertisement

10

Light Assembly

10a. Install light bulbs into powehead (F).
10a
Each light bulb must be 100 W or less*
Motor Cover
* Note: DO NOT exceed maximum wattage. Each light bulb should be no more than 100W.
(Model 2562 requires light bulbs of no more than 60 watts.)
10b. I nsert powerhead lens hinge (E) into slots in motor cover on powerhead (F).
10c. Swing lens (E) up into place. (It may be necessary to squeeze lens slightly to align
tabs with slots at top of motor cover).
10b
F
E
Compact CFL bulbs can be used.
F
10c
Tab
11

Connecting Power

For Grounded Outlet connection:
11a. Plug in the power cord. Coil excess cord and tape or twist tie it to top of
powerhead. (DO NOT PLACE ABOVE LIGHT BULBS.)
W A R N I N G
Opener is equipped with grounded electrical plug for your protection, and only fits
grounded electrical outlets. DO NOT alter plug in any way! If you have no grounded
outlets, have one installed by a licensed electrician. Opener must be properly ground-
ed to prevent personal injury and equipment damage. NEVER USE AN EXTENSION
CORD! Check local building codes for any requirement that you must have a
permanent hard-wired connection. NEVER REMOVE MOTOR COVER. All work inside
cover must be performed by a licensed electrician using proper tools and instructions.
For Permanent Wiring by an Electrician:
11a. Cut existing wires OUTSIDE CHASSIS.
11b. T he wire connections must be made INSIDE
CHASSIS and there must be at least 6" of
new power supply line wire INSIDE CHASSIS.
(Conduit is optional. Conduit, strain relief, and
wire nuts are not provided.)
Toroid
Hot
Wire nuts
12
Ready to Program
Refer to Operation and Maintenance Manual for programming instructions.
DO NOT run opener until travel limits have been set to avoid damage to unit.
11b
OR
Ground
Hot
Wire nuts
Neutral
C A U T I O N
Ground
Neutral

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poster

Table of Contents