Install Wireless Wall Console; Install Led Light Fixture - Genie Pro Series Installation, Programming, & Operation

Install Wireless Wall Console

1. Determine mounting location for wireless wall console.
2. Mount console no less than 5 feet above floor to prevent small children
from activating opener.
3. Pre-drill 3/32" holes for mounting screws, or 3/16" if using drywall anchors
(supplied) if needed.
4. Install bottom screw leaving a 1/8" gap.
5. Slide console onto screw and down slightly to lock in place.
6. Remove upper battery door and remove protective tab and batteries.
7. Install top screw to secure console to the wall.
8. Install batteries and battery door.
9. Install warning decal in the same area as wireless wall console.
Wireless Wall Console will automatically pair when opener is powered up.
1. Wireless Wall Console is now paired to opener and will operate as normal.
Wall Console Operation
1. DOOR Button - Runs garage door opener.
2. DELAY Button - Adds a 10+ second delay for door operation. Press the delay button and door
1
will automatically operate after set delay. Can be activated up to 3 times for a 10, 22 or 30
2
second delay.
3
3. LIGHT Button - Overrides the automatic timed light function of the garage door opener.
Install Bluetooth® Light Fixture
1. Determine mounting location within 30 feet of opener.
2. Pre-drill 3/32" holes for mounting screws, or 3/16" if using drywall anchors (supplied) if needed. 7-1/2 in.
inches apart.
3. Install supplied screws leaving an 1/8" gap for mounting.
4. Route power cord through cutouts in flange and plug
light into a standard 115V outlet. Secure excess wire
under light housing.
5. Align LIGHT FIXTURE mounting holes with screws and
turn light assembly to lock into place.
LIGHT FIXTURE INCLUDED WITH OPENER:
1. Power up Wall Mount Opener.
2. Power LIGHT FIXTURE.
Light will automatically pair when opener is powered up.
3. LIGHT FIXTURE will flash and beep briefly.
4. LIGHT FIXTURE will flash again indicating that it is now paired to
the opener.
FINISHING THE INSTALLATION
Open cover and remove
Drywall
Anchors
Mounting
Screws
Lower mounting slot
battery tab before
programming
AAA
AAA
13