Attaching Door Bracket To Door - Genie screwdriver Assembly & Installation

6

Attaching Door Bracket to Door

Sectional Door (Typical):
6a. Center bracket on door, higher than the
top set of door rollers.
6b. Using bracket, mark holes on door or
frame.
6c. Drill 1/8" holes.
6d. Secure with 1/4"–20 x 3/4"
self-drilling screws.
6e. Some garage door manufacturers
provide door brackets that CAN be
used with your Genie Door Arms.
Sectional Door (Wooden):
6a. C enter bracket on door, higher than the top set of door rollers.
6b. Using bracket, mark holes on door or frame.
6c. Drill 1/8" holes completely through door.
6d. Fasten bracket with 5/16" x 2"carriage bolts and nuts (not furnished).
6d 6d (alt)
Door centerline
Note: One-Piece Door (Top Edge/Face Mount) instructions are in the Operation
and Maintenance Manual provided.
Doors made of masonite, lightweight wood, fiberglass, and sheet metal must be properly
braced before mounting door opener. Contact door manufacturer or distributor for any
questions or concerns. The Genie® Company is not responsible for any damage caused
due to an improperly braced door.
(ORANGE BAG hardware)
6a
Top Roller
Door centerline
r o l
t o p
h a n
e r t
l o w
n o
c h
A t t a
6d (alt)
Door centerline
Door centerline
C A U T I O N
7
7a. Secure emergency release handle to
cord (L) and attach emergency release
cord to shuttle in rail (J).
7b. Using the emergency release cord,
disengage the shuttle/carriage.
l e r
7c. S ectional Doors typically accept
curved door arm (D). In some cases,
straight door arm (F) may be used if
the door bracket is mounted on the
top edge of door.
7d. With the door closed, the angle from door
arm (D) to header is 30˚ max.
Note: One-Piece Door (Top Edge/Face Mount)
instructions are in the Operation and Maintenance Manual provided.
7c
Clevis pin
D
or
7c (alt)
Clevis pin
Attaching Door Arm to Door
Bracket and Shuttle
7a
7c (alt)
Clevis pin
J
F Cotter pin
7d
D
Cotter pin
Door bracket
(BLUE BAG hardware)
L
J
Release handle
Orange Bag
D
Cotter pin
Door bracket
Door end rail section
Header
30° max
F
Door
D
3/8"-16 x 7/8"
Bolt &
3/8" Lock nut