Maintenance and Adjustments
F. LIGHT BULB REPLACEMENT
WARNING
!
•
Use extreme caution when working from a ladder or step
stool or serious injury can occur.
•
When replacing light cover, make sure wires are not pinched
or near moving parts.
•
Use only properly rated incandescent, LED or CFL light bulbs.
•
DO NOT use bulbs with a rating greater than 60 Watts.
•
Use A19 size light bulbs. DO NOT use bulbs having a short
neck.
Changing Light Bulbs
1.
Disconnect power to door opener.
Open powerhead light cover(s) by pressing down on upper
locking tabs.
•
Replace old light bulb(s) with new.
•
Use 60 watt incandescent bulbs or the CFL or LED equivalent.
•
Close powerhead light cover(s).
2.
Reconnect power to door opener.
Test light operation.
NOTE: Use of LED bulbs may reduce the range of your
remote controls.
Visit www.GenieCompany.com for more information and
recommendations for LED bulbs.
16
(continued)
AVERTISSEMENT
!
•
Faire particulièrement attention lors de travaux e ectués
depuis une échelle ou en escabeau.
•
En referment le couvercle de l'éclairage, s'assurer que les ls
ne sont ni coincés ni près des pièces mobiles.
•
Utilisez uniquement incandescence correctement classé, LED
ou des ampoules uocompactes.
•
NE PAS utiliser des ampoules avec une note supérieure à 60
Watts
•
Utilisez A19 ampoules de taille. NE PAS utiliser des ampoules
ayant un cou court.
LIGHT BULB
LIGHT COVER
SWINGS OPEN