F. Light Bulb Replacement
•
Use extreme caution when working from a ladder or step
stool or serious injury can occur.
•
When replacing light cover, make sure wires are not pinched
or near moving parts.
•
Use only properly rated incandescent, LED or CFL light bulbs.
•
DO NOT use bulbs with a rating greater than 60 Watts.
•
Use A19 size light bulbs. DO NOT use bulbs having a short
neck.
Changing Light Bulbs
1.
Disconnect power to door opener.
Open powerhead light cover(s) by pressing down on
upper locking tabs.
•
Replace old light bulb(s) with new.
•
Use 60 Watt MAX. incandescent bulbs or the CFL or LED
equivalent.
•
Close powerhead light cover(s).
2.
Reconnect power to door opener.
•
Test light operation.
NOTE: Use of LED bulbs may reduce the range of your remote
controls. Visit www.GenieCompany.com for more information
and recommendations for LED bulbs.
NOTE: SilentMax Connect™ models require a minimum 40
Watt or equivalent bulb, 60 watt maximum.
G. Chain/Belt Tension
If excessive chain/belt sag is noticed below the rail:
1.
Open the door until carriage is about mid travel and stop.
2.
Disengage the carriage and manually close the door.
3.
Loosen nuts on turnbuckle using 7/16" wrenches.
4.
Rotate turnbuckle counter-clockwise until slack is removed from
chain/belt.
5.
When measured on the opposite side of the rail from the
turnbuckle, a properly adjusted chain will have a 1/4" gap to the
bottom of the rail.
6.
Tighten nuts to secure turnbuckle.
7.
Be sure that chain/belt is not twisted or bound.
8.
Manually open door to re-engage carriage to turnbuckle.
14
MAINTENANCE & ADJUSTMENTS
WARNING
!
* Genie LED light bulbs are designed to reduce or
eliminate reduced remote range issues caused by
common LED bulbs. They also o er better product
life by making them resistant to vibration caused
by the opener, and cold or damp weather. See
website for details at www.GenieCompany.com.
AVERTISSEMENT
!
•
Faire particulièrement attention lors de travaux e ectués
depuis une échelle ou en escabeau.
•
En referment le couvercle de l'éclairage, s'assurer que les ls
ne sont ni coincés ni près des pièces mobiles.
•
Utilisez uniquement incandescence correctement classé, LED
ou des ampoules uocompactes.
•
NE PAS utiliser des ampoules avec une note supérieure à 60
Watts
•
Utilisez A19 ampoules de taille. NE PAS utiliser des ampoules
ayant un cou court.
1 Light Models
Push down tabs
Pull light cover away from powerhead
2 Light Models
Pull light covers away from powerhead
1/4"