Table of Contents
Advertisement
PROCEDURE FOR REPLACING DOOR SEAL ASSEMBLY (1)
Parts required for replacing carbon loaded door seals
DO NOT attempt to carry out the following procedure
Item
Description
1
Door seal set of 4
2
CAF 30 ( Black )
Tools required for replacing carbon loaded door seals
Before proceeding with this procedure ensure that the oven is disconnected
If the oven has been operating recently please allow time for the oven to cool.
Removing Door seal
1
Open the oven door.
2
Use a pair of long nose pliers to unclip one end of the seal. (See figure 1 page 36)
3
Peel back the door seal assembly and unclip at the other end. (See figure 2 page 36)
4
Remove the residue CAF 30 adhesive with a flat head screw driver. (See figure 3 page 36)
5
Visually inspect the vitreous enamel to ensure that it is undamaged.
Fitting a New Seal
1
Clip on end of the door seal in place. Using a pair of long nose pliers, stretch the door seal
and connect the other end in place. (See figure 4, 5 & 6 page 36)
2
Visually inspect that the door seal is sitting in the rebate provided.
3*
Perform door interlock set-up procedure (See page 27-29)
4*
Perform a microwave leakage test procedure. (See page 22-23)
5
Lift the seal and applied a thin line of CAF 30 adhesive along the length of the rebate and
push the seal down. (See figure 7 page 36)
6
Seal the ends of the door seal with CAF 30 (See figure 8 page 36)
Leave the door in the open position to allow the adhesive to set.
* It is very important to carry out these procedures
Please Note
unless you have the following tools and parts.
Part Number
11C0292
31Z0186
Long nose pliers
Adhesive skeleton gun
Flat head screw driver
from the power supply.
Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 35
As required
Please note.
Quantity
1
Advertisement
Table of Contents
