Table of Contents
Advertisement
PROCEDURE FOR POWER OUTPUT MEASUREMENT
The power output specification, 1425W on this model is established under IEC 705 standard
method. This method is only workable in Laboratory controlled conditions.
An approximate method is as follows:
Tim Hortons Ovens
To carry out this test the Icon Pads need to be switched to ENGINEERING MODE PROGRAMS
See Appendix 1
1)
Fill one beaker ( glass or plastic ) with one litre ( 1.78 pints ) of tap water ( at about 68ºF/
20ºC ) and measure the water temperature.
( Use a thermometer with a
2)
Place the beaker in the centre of the cavity.
General Market Models
3)
Set Time to 1 minute 3 seconds and Power to 100%
Wait until the counter reaches zero.
Tim Hortons Ovens
With the oven in ENGINEERING MODE ( see Appendix 1) Press Pad 01 (Cake) and any
Load Pad ( Quarter, Half, Full ) Wait until the counter reaches zero.
4)
Take the beaker out immediately stir the water with a plastic implement and measure the
water temperature.
5)
Calculate the temperature rise of water in the beaker. The temperature rise of the water
should be within the following range:
Temperature Rise
27ºF ( 15ºC )
36ºF ( 20ºC )
Power Output is affected by the line voltage under load.
For correct Power Output measurement, the line voltage under load must be correct.
1
/
, 0.1 degree gauge ).
10
Minimum
Maximum
Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 24
Advertisement
Table of Contents
