Operation; Filter Quick; Changing Filter - Garland MASTER SERIES Installation And Operation Manual

OPERATION

Filter Quick

IMPORTANT: never operate the filter unless the fryers
have been brought up to a cooking temperature, and filter
heater has been turned on for at least 30 minutes .
The Filter Quick System revolves around two original
inventions – one, the Power shower that snaps into the
frypot and – two, the self-aligning filter holder that can be
lifted out and cleaned easily .
1 . Shut down Fryer by rotating thermostat dial clockwise .
2 . Snap power shower into frypot connection . The inlet tube
on the Power shower snaps into a fitting in the frypot .
3 . Open Drain Valve . Drain valve safety switch will turn Fryer
off if operator forgets .
 . Pull filter lever to start filter pump ., clean filtered fat
is pumped to the Power shower . A carefully designed
shower pattern directs jets of hot fat down over every
inch of the frypot . Crumbs and sediment are flushed off
sides and splash area into the filtering system .
5 . After shorting is completely filtered, close drain valve,
allow fryer to fill before disengaging the filter level to turn
off the filter pump .
6 . Remove power shower assembly
7 . Set Temperature to start cooking
Part 1382606 Rev 2 (12/07)
The entire filtering operation is automatic and usually
requires only three (3) minutes in the 35 lbs fryer . The
operator does not have to handle a hot hose, which can
be dangerous, or change a hot filter . Employees are free to
do other tasks while filtering is in progress . As many as six
35 lb GARLAND gas fryers may be batteried together and
manifolded to a single Filter Quick System . One fryer may
be filtered while others are still in use . As each is filtered and
refilled, the next fryer can be filtered by moving the Power
shower and repeating the operation .

Changing Filter

1 . Removing the filter holder is accomplished by gently
pulling the insulated handle on the filter holder towards
you, disconnecting the filter from the pump and pulling
the caster-mounted drain drawer out of the cabinet
2 . Once you have disconnected the filter, you are now ready
to pull out the drain pan and remove the crumb screen .
3 . Remove the dirty filter paper and replace with clean new
paper . The dirty filter paper can be removed, its holder
cleaned and clean filter paper and filter powder installed
– all in a slack time period . Use extreme caution not
to contaminate the filter holder with sediment when
removing the dirty filter paper .
 . Push the drawer back into place . The self-aligning slip
connection is made to the pump and the system is ready
for use . The complete change is made in less than a
minute .
The Filter Quick system saves fat, labor costs and makes a
formerly hard job easy
Page 7