Connecting The Scansnap - Fujitsu ScanSnap S1100 Getting Started Manual

Connecting the ScanSnap

Only one ScanSnap can be connected to a computer at a time.
Use only the cable supplied with the ScanSnap.
1.
Remove the tape
on the ScanSnap.
2.
Connect the USB cable to the
USB connector on the ScanSnap
and the USB port on your
computer.
When connecting to USB hub, make sure to connect the ScanSnap to
the USB hub which is connected to a USB port of your computer. Use
a powered USB hub (with AC adaptor).
If USB port or USB hub is USB 1.1, scanning speed will slow down.
Connect the USB cable with the USB mark facing up.
3.
Open the feed guide of the
ScanSnap.
The ScanSnap is powered on and the
[Scan/Stop] button lights in blue.
Be careful not to drop the
ScanSnap when carrying it.
4.
Check the ScanSnap Manager icon.
The ScanSnap Manager icon
appears on the taskbar.
and seal
6
Feed Guide
The ScanSnap Manager icon
appears in the Dock.