Fujitsu ScanSnap S1100 Getting Started Manual page 12

Do not swing around, drop, or throw the ScanSnap. It may hit an object or
person, resulting in a damage or injuries.
Do not place heavy objects on the ScanSnap or perform other work on top
of the ScanSnap. Make sure not to sit down with the ScanSnap in your
pocket, or put heavy objects on top of the ScanSnap if carrying it in a bag.
If these instructions are not followed, the ScanSnap may become damaged
or an equipment failure may occur due to heavy impact to the ScanSnap.
Do not use the ScanSnap while it is covered, for example, with a blanket.
Doing so may raise the temperature inside and cause a fire.
To avoid injuries, be careful not to get your accessories (e.g. ties,
necklaces) or hair caught inside the ScanSnap.
Do not use the ScanSnap while driving a car. Doing so may prevent you
from driving carefully, which can cause an accident.
When the ScanSnap is not going to be used for a long period of time, be
sure to disconnect the USB cable from the ScanSnap and computer. Not
doing so may cause a fire or electric shock.
Before you perform cleaning, you must turn off the ScanSnap and unplug
the USB cable to avoid the risk of fire or electric shock.
Do not use any aerosol sprays or alcohol based sprays to clean the
ScanSnap. Dust blown up by strong air from the spray may enter the inside
of the ScanSnap. This may cause the ScanSnap to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and
dirt from the outside of the ScanSnap may cause a fire.
Check the following items once a month:
The USB cable is firmly inserted into the ScanSnap and computer.
The USB cable is not emitting abnormal heat, or the cable is not rusty or
bent.
Dust is not accumulated on the USB cable. If so, wipe off any dust with a
soft, dry cloth.
The USB cable does not have any cracks or scratches.
If any abnormality is detected, contact your FUJITSU scanner dealer or an
authorized FUJITSU scanner service provider.
AUTION
When installing the ScanSnap on a table, make sure that the work surface
is flat and stable, and that none of the ScanSnap's parts extend over the
table edge, otherwise it may fall over or be pulled off the table and cause
injuries.
12