Regulatory Information - Fujitsu ScanSnap S1100 Getting Started Manual

Regulatory Information

FCC Declaration
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction document,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is located.
Consult your dealer or an experienced radio/TV technician.
FCC warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTICE The use of a shielded interface cable is required to comply with the
Class B limits of Part 15 of FCC rules.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B limit for radio noise emissions
from digital apparatus set out in the Radio interference Regulations of the
Canadian Department of Communications.
This Class B digital apparatus complies with Canadian ICES-003.
Le présent appareil numérique n'émet pas de parasites radioélectriques
dépassant les limites applicables aux appareils numériques de la classe B et
prescrites dans le Règlement sur le brouillage radioélectrique dictées par le
Ministère des Communications du Canada.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Bescheinigung des Herstellers/Importeurs
Für den Scanner wird folgendes bescheinigt:
In Übereinsstimmung mit den Bestimmungen der EN45014(CE) funkentstört
Maschinenlärminformationsverordnung 3. GPSGV: Der höchste
Schalldruckpegel beträgt 70 dB (A) oder weniger, gemäß EN ISO 7779.
Dieses Gerät wurde nicht für die Benutzung in unmittelbarer Umgebung starker
Lichtquellen (z. B. Projektoren) konzipiert.
15