Table of Contents
Advertisement
Introduction
Thank you for purchasing the fi-680PRF (Front-Side
Imprinter) / fi-680PRB (Back-Side Imprinter).
About This Product
This product is an option that can be used with the
fi-6400/fi-6800 Color Image Scanner.
This manual describes the following two Imprinters.
Product
Model
Name
fi-680PRF FI-680PRF
fi-680PRB FI-680PRB
About This Manual
This manual describes how to use the Imprinter. Read
this manual to ensure correct use.
For how to use the fi-6400/fi-6800 Color Image Scanner
(hereinafter called "the scanner"), refer to the fi-6400/
fi-6800 Image Scanner Operator's Guide in the Setup
DVD-ROM provided with the scanner.
We hope this manual will be helpful in your future use of
the Imprinter.
Trademarks
Microsoft, Windows, Windows Server, and Windows
Vista are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other
countries.
Other company names and product names are the
registered trademarks or trademarks of the respective
companies.
Manufacturer
PFU Limited
YOKOHAMA i-MARK PLACE, 4-4-5 Minatomirai,
Nishi-ku, Yokohama, Kanagawa, 220-8567, Japan
© PFU Limited 2009-2017
Device Name
Collective
Name
Front-Side
Imprinter
Imprinter
Back-Side
Imprinter
Regulatory Information
FCC Declaration
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instruction document, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is located.
Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
The use of a shielded interface cable is required to
！
！ ！
comply with the Class B limits of Part 15 of FCC
rules. The length of the power cable must be 3
meters (10 feet) or less.
Safety Standards for LED Products
Class 1 LED Product
The fi-6400/fi-6800 image scanner is classified as a
Class 1 LED product, which conforms to IEC 60825-1,
an international standard for laser products, and EN
60825-1, a standard adopted by CENELEC (Comité
Européen de Normalisation Électrotechnique).
2
Advertisement
Table of Contents
