Table of Contents
Advertisement
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Lamp (red)
5 TIMER Indicator Lamp (green)
6 SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
7 SWING Indicator Lamp (orange)
(VERTICAL SWING)
G
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 16 Auto Restart).
8 Intake Grille
9 UP/DOWN Air Direction Flap
0 RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flap)
Fig. 4 Remote Control Unit
A SLEEP button
B MASTER CONTROL button
C SET TEMP./SET TIME buttons (
D Signal Transmitter
E TIMER button
F FAN CONTROL button
G START/STOP button
H AIR FLOW DIRECTION
VERTICAL SET button
I AIR FLOW DIRECTION
VERTICAL SWING button
J AIR FLOW DIRECTION
HORIZONTAL SET button
K AIR FLOW DIRECTION
HORIZONTAL SWING button
L TIME ADJUST button
M ACL button
(located inside battery compartment)
Rear side (Fig. 5)
N TEST RUN
G Touch the two metal contacts with a me-
tallic object to send the signal to perform
a test run.
G Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner's thermostat will
malfunction.
G If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit's OPERATION and TIMER
indicator lamps will flash simultaneously.
G To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
O Remote Control Unit Display (Fig. 6)
P Transmit Indicator
Q Clock Display
R Operating Mode Display
S T imer Mode Display
T Fan Speed Display
U Temperature Set Display
V T imer Set Indicator
W Temperature Set Indicator
)
En-4
Advertisement
Table of Contents
