Selecting Line Voltage - Fluke 5725A Getting Started

5725A
Amplifier

Selecting Line Voltage

The 5725A arrives from the factory configured for the line
voltage normally appropriate for the country of purchase,
or as specified at the time of purchase. Check the line
power label on the rear panel of the 5725A to verify that
the line voltage matches local line power. Figure 4 shows
the location of the line power label and switches, and the
switch settings for each line voltage.
14
The 5725A can be set to operate from eight different
nominal line voltages; each voltage setting has a voltage
tolerance of ±10 % and a frequency range of 47 to 63 Hz.
The line voltage switches are located on the bottom left
side of the rear panel.
To change the line voltage setting, set the line voltage
selection switches to the correct setting shown in
Figure 4.