Table of Contents
Advertisement
5725A
Amplifier
A
CURRENT OUTPUT Binding Posts
The source of all amplified current if the 5725A is configured for front output. You can set the 5700A to source
all unamplified as well as amplified current through these binding posts. The LO binding post is isolated from
ground when in the current function, and is open-circuited at other times. Cable and connection
recommendations are made in Chapter 4 of the 5700A/5720A Series II Operator Manual.
B
5725A STANDBY Indicator
Lit whenever the 5725A is in any of three standby modes. This indicator is lit alone in standby mode; it is lit at
the same time as VOLTAGE MODE in voltage standby mode; and it is lit at the same time as CURRENT
MODE in current standby mode. (See "5725A Operating Functions and Modes," in Chapter 3 of the Instruction
Manual.)
C
CURRENT MODE Indicator
Lit when the 5725A is in current standby or current operate mode. In current standby mode, the STANDBY
indicator is also lit. (See "5725A Operating Functions and Modes," in Chapter 3 of the Instruction Manual.)
D
VOLTAGE MODE Indicator
Lit when the 5725A is in voltage standby or voltage operate mode. In voltage standby mode, the STANDBY
indicator is also lit. (See "5725A Operating Functions and Modes," in Chapter 3 of the Instruction Manual.)
20
Table 3. Front-Panel Features
Advertisement
Table of Contents
