Unpacking And Inspection; Standard Equipment - Fluke 5725A Getting Started

5725A
Amplifier

Unpacking and Inspection

Warning
The 5725A amplifier is capable of supplying
lethal voltages. Do not touch the 5700A
output terminals. Read this section before
operating the 5725A.
The 5725A is shipped in a container that is specially
designed to prevent damage during shipping. Inspect the
5725A carefully for damage, and immediately report any
damage to the shipper. Instructions for inspection and
claims are included in the shipping container.
Amplifier
Line Power Cord
Shielded 5700A/5725A Interface Cable
5725A Getting Started Manual
5725A CD-ROM (contains Instruction Manual)
Spare 4A, 250V Fuse
Certificate of Calibration
8
Table 1. Standard Equipment
Item
If you need to reship the 5725A, use the original
container. If it is not available, you can order a new
container from Fluke by identifying the amplifier's model
and serial number.
When you unpack the 5725A, check for all the standard
equipment listed in Table 1. Report any shortage to the
place of purchase or to the nearest Technical Service
Center. Visit Fluke web site for Service Center locations.
If performance tests are required for your acceptance
procedures, refer to Chapter 3 of the 5700A/5720A Series
II Service Manual for instructions.
Line power cords available from Fluke are listed in
Table 2 and illustrated in Figure 2.
Model or Part Number
5725A
(See Table 2 and Figure 2)
842901
1780175
1780182
216846
(No Part Number)