Flash Card Installation Instructions - Emerson Vission Control Manual

Note: Before Powering Down To Replace Flashcard, You Must
Copy Down All Setpoints As These Will Need To Be Re-entered
When New Flashcard Is Installed.
VANTAGE/VISSION
EMERGENCY
STOP BUTTON
Disconnect the Connector And
Ribbon As Shown
74

Flash Card Installation Instructions

Hit The Emergency Stop Botton
Located In Front Of the Panel
Verify Unit is Shut Down Completely
Verify Lockout Disconnect On Compressor Start.
This Ensures Compressor Does Not Start.
Proceed As Follows
Remove (4) Screws, One In
Each Corner Of Board
Flip Board Over To
View Flash Card
View Inside Of Door