Euconized Channel Types; Global Settings - Euphonix MC Control Artist Series Setup Manual

Artist Series
professional control surfaces
3.1.1

EuConized channel types

The EuConized channel types section contains checkboxes that determine
which channel types appear on your control surface. If a certain channel is
available in Nuendo and the corresponding checkbox is selected, that channel
can be selected to appear on the surface. This channel is called EuConized.
All channels except Input channels are EuConized by default and can appear on
the surface. This is useful to eliminate tracks from the surface, reduce memory
usage, and reduce the time needed to build the EuCon mixer model when con-
necting, adding, or removing tracks from the Nuendo project.
To enable/disable EuConized tracks, select the checkbox next to each type.
Tracks without a checkmark do not appear on the surface. This setting applies
only to the open project.
3.1.2

Global Settings

The Global Settings section has two parameters: Tape machine style transport
and Number of knobsets to cache.
Tape machine style transport
Two Nuendo transport control modes are available for the control surface.
Toggle the modes from the Tape machine style transport option.
These transport modes affect the operation of the Stop, Fast Forward and Rewind
buttons in the following manner:
Tape machine style transport checked
Stop: The control surface STOP button halts the transport and keeps the play
head at the current position (even multiple presses), independent from Nu-
endo's preferences.
Fast Forward/Rewind: The FF/RW buttons always latch independent of the
control surface latch time preference. Repeatedly pressing the same FF/RW
button has no effect. The current action can be stopped by pressing the op-
posite wind button, STOP, or PLAY. The FF/RW also stops if it reaches the be-
ginning or end of the project.
Artist Series
9