Table of Contents
Advertisement
Installation
Instructions
(continued)
UNLOCK
LOCK
LOCKING THE FRONT ROLLERS
(some of the 30" models only)
Oven Light
To level the range:
1
Use a 1-1/4" open end key or an adj/Jstable wrench to equally unscrew the tour leveling legs two to
three turns each
2
Install an oven rack in the center of the oven,
3,
Move the range to its final position, then put a spirit level on the rack to check for levelness Take two
readings, one with the level placed diagonally first in one direction, and then the other,
4,
Use the 1-1/4" key or wrench to adjust the leveling legs, Turn each one until the range stands firm
without
wobbling,
5,
Some models are supported by smooth glide rollers to facilitate moving
If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to
prevent the range from moving
If floor is not fiat or level or if this model has rollers without
locking levers, use the 4 leveling legs to
level, support and prevent the range from moving
Donotturntheoven lightondudng theself-cleaning
cycle.
Hightemperature w ill reduce lamplife.
On some models an interior oven light will turn on automatically when the oven door is opened
The oven light may be turned on when the door is closed by using the oven light switch located on or
underneath the control panel,
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION:
BE SURE OVEN IS COOL.
1,
Turn the power oft at the main source,
2,
Wear a leather-faced glove for protection against possible broken glass,
3,
Replace bulb with a 40 waft appliance bulb only
4,
For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure
to replace glass shield,
Surface Light
(some models)
BE SURE ALL SURFACE
ELEMENT
CONTROL
KNOBS ARE TURNED
TOOFF'I"
AND ELEMENTS
ARE COOL,
Use switch located on or underneath the control panel to turn the surface light ON/OFF
Replace the surface light, if aRer repeated attempts to turn it on you are not successful,
SURFACE LIGHT REPLACEMENT
(some models)
To remove and replace the fluorescent
light:
1,
Place your fingers under the tube at approx 8" (203 cm) from each end,
2,
To remove, turn the tube 90 ° then pull it down and out of its sockets,
3
To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place,
T_Jrnon the surface light to make sure it will lit
General 7 Information
Advertisement
Table of Contents
