Table of Contents
Advertisement
SETTING OVEN CONTROLS
Adjusting the oven temperature
Your appliance has been factory calibrated and tested
to ensure an accurate baking temperature. For the first
few uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is
cooking too hot or too cool for your recipe times, you can
adjust the control so the oven cooks hotter or cooler than
the temperature displayed.
To adjust oven temperature:
1. Press bake.
2. Set the temperature to 550°F (287°C) by pressing and
holding the
.
3. Within 2 seconds, press and hold bake until numeric
digit(s) appear. Release bake keypad. The display now
indicates the amount of degrees offset between the
original factory temperature setting and the current
temperature setting. If the oven control has the
original factory calibration, the display will read "0."
4. The temperature can now be adjusted up or down
35°F (19°C), in 5°F increments by pressing and
holding the
or
amount of offset appears in the display. When
lowering the oven temperature, a minus sign (-) will
appear before the number to indicate that the oven
will be cooler by the displayed amount of degrees.
5. When you have made the desired adjustment, press
clear off to go back to the time of day display.
NOTES
Oven temperature adjustments made will not affect the
broil or self-cleaning feature temperatures.
If the display is set for Celsius, adjustments made will be
in 1°C increments each press of the
DO NOT USE oven thermometers such as those found
in grocery stores to check the temperature settings inside
your oven. These oven thermometers may vary as much
as 20 to 40 degrees from actual temperatures.
18
. Adjust until the desired
or
keys.
Setting oven lockout
The control can be programmed to lock the oven door and
lockout the oven control pads.
To set the oven lockout feature
1.
Press clear off and hold for 3 seconds. "Loc" will
appear in display, the "Door Locked" indicator light will
flash and the motor driven door lock will begin to close
automatically. Allow about 15 seconds for the oven
door to lock. Once the oven door is locked, the current
time of day will appear in the display.
2. To cancel the Oven Lockout feature, press clear off
and hold for 3 seconds. The control will unlock the
oven door and resume normal operation.
NOTES
DO NOT open the oven door while the indicator light
is flashing. Allow about 15 seconds for the oven door to
lock. Once the oven door is locked, the current time of
day will appear in the display.
If any control pad is pressed with the oven lockout
feature active, "Loc" will appear in the display until the
control pad is released.
Operating oven light
The interior oven light will automatically turn ON when the
oven door is opened. Press the oven light switch located
on the upper left control panel to turn the interior oven
light ON and OFF whenever the oven door is closed.
The interior oven light is located at the upper left rear
wall of the oven interior and is covered with a glass
shield held by a wire holder. The glass shield must be in
place whenever the oven is in use. To change the interior
oven light, see "Changing the oven light" in the Care &
Cleaning section.
oven light switch
(some models)
Advertisement
Table of Contents
