Table of Contents
Advertisement
AVOID
SERVICE
CHECK
LIST
Before
you call for service
- read
this
You may save the cost and inconvenience
of an unnecessary service call by first reviewing
this easy to use Avoid-
Service Check List of the most frequently
encountered
situations that are not the result of defective workmanship
of materials.
You will be charged for a service call while the appliance
is in warranty
if the problem
is not caused by defective
product workmanship
or materials.
Your new appliance is a carefully engineered
product.
Many times, what appears to be a reason to call for service
requires nothing
more than a simple adjustment
you can easily make in your own home or is normal operating
characteristic of appliance under certain conditions.
This list is applicable
to a variety of models: some of the items will not necessarily apply to your appliance.
PROBLEM
POSSIBLE CAUSE / SOLUTION
INSTALLATION
Range is not level.
Poor installation.
See the suggested
levelling
instruction
in the "General
Informa-
tion" section of this manual.
When oven is level, cooktop may not appear to be level
with counter top if the latter is not level.
Be sure floor is level and can adequately
support range. Contact carpenter to correct
sagging or sloping floor.
Kitchen
cabinets
misalignment
may make range appear to be unlevel.
Be sure
cabinets are square and have sufficient
room for range clearance (1.3 cm (1/2") each
side).
RANGE
DOES NOT OPERATE
Entire range does not operate.
House fuse has blown or circuit breaker has tripped.
Check and/or replace fuse or
reset circuit breaker.
Cordtplug
not plugged into wall outlet.
Make sure cord plug is plugged tightly
into
outlet (Canada only).
Power outage.
Check house lights to be sure.
Oven does not operate.
No power to range.
See steps "Entire range does not operate"
above.
Oven selector control knob (some models) set between two positions.
Turn selector
control knob to BAKE or BROIL, etc. and make sure surface signal lights turn on.
Make sure the oven temperature
control knob is set to the desired temperature.
Oven control beeps and displays -F1- or -F3-. Electronic control has detected
a fault
condition.
Push the CANCEL pad to clear the display
and stop the beeping.
Reprogram the oven. If fault recurs, record the fault number
push the CANCEL pad
and contact an authorized
servicer.
AVOID SERVICE CHECKLIST
23
Advertisement
Table of Contents
