Connecting An Analog Audio System; Connecting A Digital Audio System With Built-In Digital Surround - Toshiba 42HP66 Owner's Manual

÷
Connecting an analog audio system
This connection allows you to use external speakers with an external audio
amplifier to adjust the sound level.
To control the audio:
Turn on the TV and the stereo amplifier.
Turn off the TV's built-in speakers (see "Turning off the built-in speakers" on page
42.)
Note: To hear sound when using an external audio amplifier, the volume of both
the TV and the amplifier must be set to a reasonable listening level.
TV back panel
You will need:
• one pair of standard audio cables
Analog audio amplifier
÷
Connecting a digital audio system with
built-in digital surround
The TV's two digital audio outputs output a Dolby* Digital DB_ or 2-
channel clown-mixed PCM (pulse-code modulation) signal for use with an
external Dolby Digital decoder or other external audio system with optical or
coaxial audio input.
AV Amplifier with built-in digital surround
You will need:
• one optical audio cable or coaxial
audio cable.
Note:
Refer to the Owner's manual of the
audio amplifier as well.
Connect
either
Optical
audio cable
Coaxial
audio cable
rv back panel
1
speFrkntr \ ] TV Subwoofer / Frp°Iker
(Left) _ _ _ __ (Right)
Center Speaker
_ _Lerf_ Und S Pe ake r _ _gh_) nd Speaker
g N
÷
The COAXIAL DIGITAL AUDIO OUT jack outputs digital audio only during digital broadcasts with digital audio. To hear analog
broadcast audio, you also must connect analog audio cables from the L/R ANALOG AUDIO jacks to the receiver's inputs.
Consult the owner's manual for your receiver to determine the best way to switch between the analog and digital signals.
15
3X70121A En p10-17 15 _ 1/31/06,11:41 PM