Setting Up Your Tv; Using The Remote Control; Preparing The Remote Control For Use; Installing The Remote Control Batteries - Toshiba 42HP66 Owner's Manual

÷
÷
Setting up your TV
Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCRs, and DVD players together, even if
they are different brands. In addition to operating the TV, the remote
control can operate most cable TV converters, satellite receivers,
VCRs, and DVD players, regardless of their brand. The remote control
is pre-programmed to operate most Toshiba satellite receivers, VCRs,
and DVD players. To control a non-Toshiba device (or a Toshiba device
that the remote control is not pre-programmed to operate), you must
first program the remote control. See "Programming the remote control
to operate your other devices" on the next page.
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converte_
Refer to the owner's manual supplied with
your other devices to see which features may
be available. Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the applicable device.
Caution:
• Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose ofbatteries in a designateddisposalarea.
• Batteries shouldalways be disposed of with the
environmentin mind. Alwaysdispose of batteries in
accordancewith applicablelaws and regulations.
• If the remote control does not operate correctly,
or ff the operating range becomes reduced,
replace batteries with new ones.
• When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
• Alwaysremovebatteriesfrom remotecontrolif they
are dead or if the remotecontrolis not to be usedfor
an extendedperiod of time.This will preventbattery
acid from leakinginto the batterycompartment.
3. Close the battery cover on the remote control until the lock snaps.
Using the remote control to o
To control a cable TV
converter/satellite
receiver:
Program the remote
control to recognize the
brand of your cable TV
converter/satellite receiver
(see "Programming the
Power
Input (TV)
Mute (TV)
Channel
Numbers
CH RTN
(Channel Return)
Channel _/v
CBL/SAT
remote control to operate Volume +/- (TV)
your other devices" on the Pic Size (TV)
next page.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
TVNCR
}erate your other devices
To control a VCR:
Program the remote Input (TV)
Power
control to recognize Channel
the brand of your VCR Numbers
(see "Programming the
CH RTN
remote control to (Channel R eturn)
operate your other VCR
devices" on the next Channel _/v
page.) The buttons Volume +/- (TV)
shown at right will then Pic Size (TV)
control the VCR.
Press "VCR" first.
VCR controls --
m
÷
18
3X70121A En p18-25 18 _ 1/31/06,10:58 PM