Connecting An Analog Audio System; Connecting A Digital Audio System With Built-In Digital Surround - Toshiba 50HP16 Owner's Manual

Connecting an analog audio system

This connection allows you to use external speakers with an external audio
amplifier to adjust the sound level.
To control the audio:
Turn on the TV and the stereo amplifier.
Turn off the TV's built-in speakers (see "Turning off the built-in speakers" on page
42.)
Note: To hear sound when using an external audio amplifier, the volume of both
the TV and the amplifier must be set to a reasonable listening level.
TV back panel
Connecting a digital audio system with
built-in digital surround
The TV's two digital audio outputs output a Dolby* Digital
channel down-mixed PCM (pulse-code modulation) signal for use with an
external Dolby Digital decoder or other external audio system with optical or
coaxial audio input.
AV Amplifier with built-in digital surround
IN
Optical digital
Audio
Connect
either
Optical
audio cable
The COAXIAL DIGITAL AUDIO OUT jack outputs digital audio only during digital broadcasts with digital audio. To hear analog
broadcast audio, you also must connect analog audio cables from the L/R ANALOG AUDIO jacks to the receiver's inputs.
Consult the owner's manual for your receiver to determine the best way to switch between the analog and digital signals.
3X80501A_En_p10-17 15
IN
OR
Speaker
Coaxial digital
Audio
Coaxial
audio cable
TV back panel
You will need:
• one pair of standard audio cables
Analog audio amplifier
You will need:
• one optical audio cable or coaxial
or 2-
Note:
Refer to the Owner's manual of the
audio amplifier as well.
Front
TV
(Left)
Surround Speaker
(Left)
15
3/7/06, 3:50 PM
LINE IN
L R
audio cable.
Front
Subwoofer
Speaker
(Right)
Center Speaker
Surround Speaker
(Right)